How To Remove Rust From Canning Lids

Rusty Rings

We won't tell you that rust is adept, but it doesn't have to hateful the terminate of the road for your canning supplies.

H2o Bath Canners & Racks:

If you're using a typical agate water bath canner, chances are, it has many stories to tell and the battle scars to evidence its usefulness. Sadly, while they are light and like shooting fish in a barrel to handle, they are prone to chip and then the rusting starts. I still utilize mine – and they take a little rust.

That's OK…just exist sure that your rusty spots are not going to interfere with its functioning and safety. Apply your common sense…if the handles don't experience secure or if there is a weakness in any area of your canner, it's time to replace information technology. I of these days, I'll need to replace mine, merely non quite yet! (When that time comes, in that location are many creative & useful ways to re-purpose old canners or racks!)

I just needed to replace my canning rack for my large water bath canner, as information technology was just too visually rusty and and then piece of cake to replace. I'd also plant that a cake rack or a rack made of bands worked ameliorate for the broad range of jar sizes I'd been using. Information technology didn't have dividers and gave me more than flexibility in spacing my jars.

Canning Rings :

A little rust on the exterior of your rings isn't a bad matter. However, you do desire to stay abroad from the rings that become distorted or take rust on the within or any part that will be in contact with your lid or the jar. If the rust is against your lid or jar, it may not interfere with the sealing process, but it will likely transfer rust onto your lid or jar…which volition non look very nice- especially if y'all end up gifting or sharing those goods.  Here are some ideas on how to re-purpose those old rings!

Here some tips on avoid that pesky oxidation!

The best way to avoid rust is quite uncomplicated…to limit the contact with h2o or moisture. Sounds like shooting fish in a barrel, right?

Don't forget to empty and make clean your canner & drying rack in a timely fashion.

I'm not sure what your order of operations is when you're canning, but mine usually is worked in with something else. So, after I remove the last batch of jars from the canner and gear up them lovingly on the counter to cool, I'm on to cleaning up the mess that I made or getting supper ready, laundry, email, helping the kids…annihilation simply hauling that hot canner of water out to the worm pile. Thus, it sets at that place with h2o in it until the kids go to bed. I know, it'south not platonic.  I'll try to practise better! Please note, though…information technology is of import to permit that water cool downwardly plenty (absurd enough to touch) before handling information technology…information technology's not worth getting burned in the effort to deter rust.

Don't forget to remove those rings or bands from your sealed jars.

This should be happening anyhow for safety purposes, merely this is just another benefit of removing them. Rusting bands on jars can make it hard to open the jars and quite only looks bad.

It is possible (particularly during prolonged h2o bath times) that some contents exited the jars and would be deposited on everything in your canner. When you know this has happened, information technology's particularly of import to wash them with warm soapy water.

Dry everything thoroughly!

Almost canners and all racks and rings/bands accept curled edges or tight joints that concord h2o…making it impossible for even the best towel dryer to remove.  I will often put my oven on warm and identify my washed and towel dried h2o bath canner, metal rack and metal bands into the oven for a warm bake to ensure that the wet is driven out.

Source: https://www.fillmorecontainer.com/blog/2014/09/17/is-it-ok-if-my-water-bath-canner-or-canning-rings-are-rusty/

Share this post